MaxxECU has established itself as a race proven engine management system worldwide. It’s an affordable engine management solution that offers motorsport level features and tuning. The problem? The software is fairly complex, requiring a lot of very specific knowledge to properly program. We have the solution! Our 30+ hour MaxxECU training course cuts through the days, weeks, or years long learning curve and brings you the knowledge you’ll need to successfully map your own vehicle. New to tuning MaxxECU? No problem, we have you covered! We start with the basics of downloading/installing the MTune software and walk you through each training lesson in very specific order so you can learn most efficiently. You’ll learn how to properly configure a base calibration file using the MTune software and be able to tune from cold start to full throttle pulls! In addition, we take things a step further and show you the tuning process from start-to-finish on our chassis dyno with various vehicles to illustrate all the concepts and techniques we learned in the training course!
MaxxECU Training Course Topics
Main Rev Limiter, 2-Step, & 3-Step Limiters
Drag Race Anti-Lag
Variable Cam Control
Nitrous Control
Water / Meth Injection Tuning
Timers
Drive-By-Wire Throttle
Traction Control
VTEC Tuning
Dual Tables
Fuel Injection Timing
Coil Dwell Programming
Automatic Transmission Control
4-D Table Tuning
VE Fuel Model Tuning
Fail-Safe Protection
Fuel Injection Timing
Injector Data / Coil Dwell
Software Download & Installation
Calibration File Editing
Uploading / Downloading Calibration Files
Fuel Tables & Rescaling
Flex Fuel Tuning
Cranking, Post-Start, & Warm-Up
Idle Control
Closed Loop O2 Fuel Control
Spark Timing Table
Acceleration & Deceleration Fuel
Load Cell / Full Throttle Shift Gear Cut
Alpha-N Tuning
Speed/Gear Set-Up
Datalogging
Knock Control
Cam/Crank Trigger Set-Up